Rear Compartment Lid Position Switch Adjustment

Rear Compartment Lid Position Switch Adjustment

Adjustment Procedure




1. Place the folding top in the up position.
2. Open the rear compartment.
3. Place a protective covering over the interior and the adjacent body panels.




4. Loosen the screw (2) on the position sensor switch.




5. Verify that the pin (2) on the position sensor switch is positioned between the bracket (3) and the link actuator (1).
6. Adjust the position sensor switch so that the link actuator (1) depresses the pin (2).




7. Apply LOCTITE(TM) Blue, GM P/N 12345382 (Canadian P/N 10953489) or equivalent to the bolts.

Caution: Refer to Fastener Caution (Fastener Caution).

8. Tighten the position sensor switch screw (2) to 2.5 Nm (22 lb in).
9. Remove the protective covering.
10. Close the rear compartment.
11. Cycle the folding top under power through one complete cycle in both directions.
12. Inspect the folding top for proper operation. Refer to Power Folding Top Description and Operation (Power Folding Top Description and Operation).