Ignition Coil(s) Replacement - Bank 1

Ignition Coil Replacement - Bank 1

Removal Procedure




1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement (Service and Repair).
2. Disconnect the ignition coil wiring harness electrical connector from the coil that is being replaced.




3. Remove the ignition coil retaining bolt.
4. Remove the ignition coil.

Installation Procedure





Note: Ensure that the spark plug seal is in place when installing the ignition coil.

1. Install the ignition coil.

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the ignition coil retaining bolt and tighten to 10 Nm (89 lb in).
3. Connect the ignition coil electrical connector.
4. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement (Service and Repair).