133. Crankshaft Balancer Installation

Crankshaft Balancer Installation

Special Tools
* EN 46106 - Engine Flywheel Holding Tool
* J 41998-B - Crankshaft Balancer Installer
* J 45059 - Angle Meter
For equivalent regional tools, refer to Special Tools (Special Tools).




1. The EN 46106 - tool must be installed onto the flywheel.
2. Use the J 41998-B - installer , nut, bearing and washer to install the crankshaft balancer.





Note: Do not lubricate the crankshaft front oil seal or crankshaft balancer sealing surfaces. The crankshaft balancer is installed into a dry seal.

3. Apply lubricant to the inside of the crankshaft balancer hub bore.




4. Place the crankshaft balancer in position on the crankshaft.
5. Thread the J 41998-B - installer in the crankshaft. Ensure you engage at least 10 threads of the J 41998-B - installer before pressing the crankshaft balancer in place.
6. Push the crankshaft balancer into position by tightening the nut on the J 41998-B - installer until the large washer bottoms out on the crankshaft end.
7. Remove the J 41998-B - installer.




8. Install the NEW crankshaft balancer bolt.

Caution: Refer to Fastener Caution (Fastener Caution).

9. Tighten the crankshaft balancer bolt.

* Tighten the crankshaft balancer bolt to 100 Nm (74 lb ft).
* Tighten the crankshaft balancer bolt an additional 150 degrees using the J 45059 - meter.




10. Remove the EN 46106 - tool.