74. Oil Pan Cleaning and Inspection

Oil Pan Cleaning and Inspection (AWD)

Special Tools

J 28410 - Gasket Remover

For equivalent regional tools, refer to Special Tools (Special Tools).

Cleaning Procedure

1. Remove any old thread sealant, gasket material or sealant using J 28410 - remover.
2. Clean the oil pan and oil pan components in solvent.
3. Clean out debris from the bolt holes.
Warning: Refer to Safety Glasses Warning (Safety Glasses Warning).

4. Dry the oil pan and oil pan components with compressed air.

Inspection Procedure




1. Inspect the exterior of the oil pan for the following conditions:

* Dents or damage to the exterior (1)
* Damage to the drain plug or drain plug hole (2)
* Damage to the transaxle brace mounting bosses (3)
* Damage to the transaxle mounting bosses (4)




2. Inspect the interior of the oil pan for the following conditions:

* Gouges or damage to the oil pan sealing surfaces (1)
* Damage to the oil pan scraper mounting holes (2)
* Damage to the bolt holes (3)

3. Repair or replace the oil pan and/or oil pan components as necessary.