131. Engine Flywheel Installation (Automatic Transmission)

Engine Flywheel Installation (Automatic Transmission)

Special Tools
* EN 46106 - Flywheel Holding Tool
* J 45059 - Angle Meter
For equivalent regional tools, refer to Special Tools (Special Tools).

1. Place the engine flywheel in position on the crankshaft.
2. Install 2 NEW bolts in location at the top and bottom of the engine flywheel bolt pattern allowing the engine flywheel to hang in position.




3. Install the EN 46106 - tool.





Caution: Refer to Fastener Caution (Fastener Caution).

4. Install the remaining NEW engine flywheel bolts.

1. Tighten the NEW engine flywheel bolts to 30 Nm (22 lb ft).
2. Tighten the NEW engine flywheel bolts an additional 45 degrees using the J 45059 - meter.




5. Remove the EN 46106 - tool.