C0245

DTC C0245

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Strategy Based Diagnosis) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Diagnostic Procedure Instructions) provides an overview of each diagnostic category.

DTC Descriptor
DTC C0245 00
- Wheel Speed Sensor Frequency Error

Circuit/System Description

As the wheel spins, the wheel speed sensor produces an AC signal. The electronic brake control module (EBCM) uses the frequency of the AC signal to calculate the wheel speed.

Conditions for Running the DTC

* Ignition ON.
* Ignition voltage is greater than 8 volts.
* Vehicle must be moving at a speed less than 14.5 km/h (9 mph).
* No wheel speed sensor faults exist.
* Brake is not applied.
* Vehicle is not cornering.
* No wheel spinning is detected.

Conditions for Setting the DTC

Wheel speed differences between one wheel and the others is greater than 25 percent.

Action Taken When the DTC Sets

* The ABS, traction control system (TCS) and vehicle stability enhancement system (VSES) are inhibited.
* The ABS indicator illuminates.

Conditions for Clearing the MIL/DTC

The condition for the DTC is no longer present.

Diagnostic Aids

* Faulty wheel speed sensor will not set this DTC.
* A vehicle using a space saver spare will not set this code.

Reference Information
Schematic Reference

Antilock Brake System Schematics (Electrical Diagrams)
Connector End View Reference

Component Connector End Views (Connector Views)
Description and Operation

ABS Description and Operation (Description and Operation)
Electrical Information Reference

* Circuit Testing (Circuit Testing)
* Connector Repairs (Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (Testing For Intermittent Conditions and Poor Connections)
* Wiring Repairs (Wiring Repairs)

Scan Tool Reference

Control Module References (Programming and Relearning) for scan tool information

Circuit/System Verification

Inspect for one tire that has improper air pressure or improper size.