58. Valve Spring Inspection and Measurement

Valve Spring Inspection and Measurement

Special Tools

J 22738-B - Valve Spring Tester

For equivalent regional tools, refer to Special Tools (Special Tools).




1. Place the valve spring in the J 22738-B - tester.
2. Compress the J 22738-B - tester to the valve open, valve spring compressed, dimension listed in the Engine Mechanical Specifications (LD8) (Service Limits & General Specifications (VIN Y))Engine Mechanical Specifications (L37) (Service Limits & General Specifications (VIN 9)).

Caution: DO NOT use shims in order to increase valve spring load. The use of shims will cause the valve spring to bottom out before the camshaft lobe is at peak lift and engine damage could result.

3. If low valve spring load is found to be too low, replace the valve spring, DO NOT shim.