Steering Linkage Outer Tie Rod Replacement

Steering Linkage Outer Tie Rod Replacement

Special Tools

J 24319-B Steering Linkage and Tie Rod Puller

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation (Service and Repair).




3. Remove the outer tie rod retaining nut (2).




4. Loosen the jam nut (2) on the inner tie rod (1).




5. Using J 24319-B remove the outer tie rod from the steering knuckle.




6. Remove the outer tie rod (3) from the inner tie rod (1).

Installation Procedure




1. Install the outer tie rod (3) to the inner tie rod (1).
2. Do not tighten the jam nut (2).




3. Install the outer tie rod (2) to the steering knuckle (1).





Caution: Refer to Fastener Caution (Fastener Caution).

4. Install the outer tie rod retaining nut (2).

Tighten the nut to 30 Nm plus 180 degrees (22 lb ft plus 180 degrees).

5. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation (Service and Repair).
6. Lower the vehicle.

Note: Ensure that the rack and pinion boot is not twisted or puckered during toe adjustment.

7. Adjust the front toe. Refer to Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment (Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment).