Operation CHARM: Car repair manuals for everyone.

B2923




DTC B2923

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Strategy Based Diagnosis) for an overview of the diagnostic approach
* Diagnostic Procedure Instructions (Diagnostic Procedure Instructions) provides an overview of each diagnostic category

DTC Descriptor
DTC B2923
- Content Theft System Inclination Sensor Signal Circuit

Diagnostic Fault Information





Circuit/System Description

When the content theft deterrent (CTD) system arms and the inclination sensor is enabled, the rear integration module (RIM) receives a power-up acknowledgement from the inclination sensor via the inclination sensor signal circuit.

Conditions for Running the DTC

* The inclination sensor is enabled
* The CTD system has armed

Conditions for Setting the DTC

The RIM does not receive the power-up acknowledgement from the inclination sensor

Action Taken When the DTC Sets

The RIM will ignore all inputs from the inclination sensor for the remainder of the CTD system arming cycle

Conditions for Clearing the DTC

A current DTC will clear when the RIM receives a power-up acknowledgement from the inclination sensor during the next CTD system arming cycle

Reference Information
Schematic Reference

Theft Deterrent System Schematics (Theft Deterrent System Schematics)
Connector End View Reference

Component Connector End Views (Connector Views)
Description and Operation

Content Theft Deterrent (CTD) Description and Operation (Content Theft Deterrent (CTD))
Electrical Information Reference

* Circuit Testing (Circuit Testing)
* Connector Repairs (Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (Wiring Repairs)

Scan Tool Reference

Refer to Control Module References (Programming and Relearning) for scan tool information

Circuit/System Verification

1. Ignition OFF, disconnect the X2 harness connector at the RIM. Disconnect the harness connector at the inclination sensor.
2. Verify a test lamp does not illuminate between the signal circuit terminal 3 at the inclination sensor and B+.

If the test lamp illuminates, test the signal circuit for a short to ground.

3. Test for less than 2 ohms between the signal circuit terminal 3 at the inclination sensor and the signal circuit terminal 10 at the RIM X2 harness connector.

If greater than the specified range, test the signal circuit for an open/high resistance.

4. Ignition ON, verify a test lamp does not illuminate between the signal circuit terminal 3 at the inclination sensor and ground.

If the test lamp illuminates, test the signal circuit for a short to B+.

5. If all circuits test normal, test or replace the inclination sensor.

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure

Theft Deterrent Vehicle Inclination Sensor Replacement (Service and Repair)