Camshaft Position Sensor Replacement - Bank 1 (Right Side) Intake

Camshaft Position Sensor Replacement - Bank 1 (Right Side) Intake

Removal Procedure




1. Turn the ignition OFF.
2. Remove the front compartment sight shields as necessary. Refer to Front Compartment Sight Shields Replacement (Service and Repair).
3. Disconnect the camshaft position (CMP) sensor electrical connector.




4. Remove the CMP sensor bolt.
5. Remove the CMP sensor.

Installation Procedure




1. Install the CMP sensor.

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the CMP sensor bolt and tighten to 10 Nm (89 lb in).




3. Connect the CMP sensor electrical connector.
4. Install the front compartment sight shields as necessary. Refer to Front Compartment Sight Shields Replacement (Service and Repair).