Ignition Coil Replacement - Bank 1

Ignition Coil Replacement - Bank 1

Removal Procedure




1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement (Fuel Injector Sight Shield Replacement).
2. Remove the ignition coil cover from the cam cover by lifting straight up.




3. Disconnect the ignition coil wiring harness electrical connector from the coil that needs to be replaced.
4. Remove the ignition coil retaining bolt.
5. Carefully remove the ignition coil.

Installation Procedure





Note: Ensure that the spark plug seals are in place when installing the ignition coil.

1. Install the ignition coil.

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the ignition coil retaining bolt and tighten to 10 Nm (89 lb in).
3. Reconnect the ignition coil electrical connector.




4. Install the ignition coil cover to the cam cover.
5. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement (Fuel Injector Sight Shield Replacement).