C0900
DTC C0900
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Strategy Based Diagnosis) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Diagnostic Procedure Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC C0900
- Device Voltage High
Diagnostic Fault Information
Circuit/System Description
The electronic brake control module (EBCM) monitors the system voltage. If the voltage level is too high, damage may result in the system. When a high voltage condition is detected the EBCM turns OFF the system relay which removes battery voltage from the solenoid valves and pump motor.
Conditions for Running the DTC
Engine running.
Conditions for Setting the DTC
The system voltage is greater than 16 volts for 100 msec.
Action Taken When the DTC Sets
* Traction Control System (TCS) and Vehicle Stability Enhancement System (VSES) disabled for the duration of the ignition cycle.
* ABS disabled if ignition voltage exceeds 19.5 volts.
* The TCS indicator turns ON.
* The Antilock Brake System (ABS) indicator turns ON if voltage exceeds 19.5 volts.
* The driver information center (DIC) displays the Service Stability System message, if equipped.
Conditions for Clearing the DTC
* The condition for the DTC is no longer present.
* The EBCM automatically clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles.
Diagnostic Aids
* A possible cause of this DTC could be overcharging with a battery charger or jump starting.
* A high voltage value in multiple modules indicates a concern in the charging system.
Reference Information
Schematic Reference
Antilock Brake System Schematics (JL7) (Antilock Brake System Schematics (JL7))Antilock Brake System Schematics (Except JL7) (Antilock Brake System Schematics (Except JL7))
Connector End View Reference
Component Connector End Views (Connector Views)
Description and Operation
ABS Description and Operation (With JL7) (ABS (With JL7))ABS Description and Operation (Without JL7) (ABS (Without JL7))
Electrical Information Reference
* Circuit Testing (Circuit Testing)
* Connector Repairs (Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (Wiring Repairs)
Scan Tool Reference
Control Module References (Programming and Relearning) for scan tool information.
Circuit/System Verification
1. Engine running measure and record the voltage at the battery terminals. Verify that the battery voltage is 12.6-15.5 volts.
• If the battery voltage is not within the specified range, refer to Charging System Test (Charging System Test)
2. Engine running, observe the scan tool EBCM battery positive voltage parameter.The reading should be between 12.6 and 15.5 volts.
• If not within the specified range, replace the EBCM.
Repair Instructions
Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.
Control Module References (Programming and Relearning) for EBCM replacement, setup and programming.