86. Intake Manifold Assemble

Intake Manifold Assemble (LF1 or LFW) (3.0L)




1. Inspect the manifold absolute pressure (MAP) sensor O-ring seal for damage. If the seal is damaged replace the MAP sensor.
2. Install the MAP sensor (2).

Caution: Refer to Fastener Caution (Fastener Caution).

3. Install the MAP sensor bolt (1) and tighten to 4 Nm (35 lb in).




4. Inspect the evaporative (EVAP) solenoid O-ring seal for damage. If the seal is damaged replace the EVAP solenoid.
5. Install the EVAP solenoid (1).
6. Tighten the EVAP solenoid bolt to 10 Nm (89 lb in).




7. Install the NEW throttle body seal (3).
8. Install the throttle body (2).
9. Install the throttle body bolts (1) and tighten to 10 Nm (89 lb in).