2. Crankshaft Balancer Removal

Crankshaft Balancer Removal

Special Tools
* J 41816-A - Crankshaft Balancer Remover
* J 41816-2 - Crankshaft End Protector
* J 42386-A - Flywheel Holding Tool

For equivalent regional tools, refer to Special Tools (Special Tools).





Caution: Refer to Fastener Caution (Fastener Caution).

Note:
* If replacing the crankshaft balancer on manual transmission applications, note the location of any existing balance weights, if applicable. Crankshaft balance weights must be installed into the new balancer in the same location as the old balancer. A properly installed balance weight will be either flush or below flush with the face of the balancer. Refer to Engine Balancing (Procedures).
* Do not use the crankshaft balancer bolt again. Install a NEW crankshaft balancer bolt during final assembly.

1. Install the J 42386-A - tool and bolts.
Use 1 M10 - 1.5 x 120 mm and 1 M10 - 1.5 x 45 mm bolt for proper tool operation and tighten the J 42386-A - tool bolts to 50 Nm (37 lb ft).




2. Remove the crankshaft balancer bolt (139). Do not discard the crankshaft balancer bolt. The balancer bolt will be used during the balancer installation procedure.




3. Use the J 41816-A - remover (1) and the J 41816-2 - protector (2) in order to remove the crankshaft balancer.




4. Remove the crankshaft balancer (1).




5. Remove the crankshaft balancer washer (1) from the balancer, as required.




6. Note the position of the crankshaft balance weights, if applicable for manual transmission applications.