Operation CHARM: Car repair manuals for everyone.

B0055




DTC B0055

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Strategy Based Diagnosis) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Diagnostic Procedure Instructions)provides an overview of each diagnostic category.

DTC Descriptor
DTC B0055 00
- Seat Side Air Bag Deployment Commanded

Circuit/System Description

The inflatable restraint sensing and diagnostic module (SDM) contains a sensing device that converts vehicle velocity changes into an electrical signal. The SDM compares this electrical signal to a value stored in memory. When the generated signal exceeds the stored value, the SDM performs additional signal processing and compares the generated signals to values stored in memory. When 2 of the generated signals exceed the stored values, the SDM will cause current to flow through the air bags, deploying the seat side air bags and causing DTC B0055 to set. This DTC is set when the SDM has commanded an air bag deployment with no faults present.

Conditions for Running the DTC

Ignition voltage is between 9-16 volts.

Conditions for Setting the DTC

* This SDM detects a frontal crash of sufficient force to warrant deployment of the frontal air bags.
* The SDM detects a side impact crash of sufficient force to warrant deployment of a seat side air bag.

Action Taken When the DTC Sets

* DTC B0052 or B0053 will set.
* The SDM requests the instrument panel cluster (IPC) to illuminate the SIR system AIR BAG indicator.
* The SDM records crash data.

Conditions for Clearing the DTC

DTC B0055 is a latched code and cannot be cleared.

Reference Information
Schematic Reference

SIR Schematics ([1][2]Air Bag Systems)
Connector End View Reference

Component Connector End Views (Connector End Views By Name)
Description and Operation

SIR System Description and Operation (Description and Operation)
Electrical Information Reference

* Circuit Testing (Circuit Testing)
* Testing for Intermittent Conditions and Poor Connections (Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (Wiring Repairs)
* Connector Repairs (Connector Repairs)

Scan Tool Reference

Control Module References (Programming and Relearning)for scan tool information

Circuit/System Testing

1. Ignition OFF, Verify that the vehicle does not show any signs of seat side impact or frontal air bag deployment.

If the vehicle displays any signs of deployment, refer to Repairs and Inspections Required After a Collision (Supplemental Inflatable Restraints).

2. Verify DTC B0055 is not set.

If DTC B0055 is set, replace the SDM.

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

* SIR/SRS Wiring Repairs (SIR/SRS Wiring Repairs)
* Control Module References (Programming and Relearning)for SDM replacement, setup, and programming