B0988
DTC B0988
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Strategy Based Diagnosis) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Diagnostic Procedure Instructions)provides an overview of each diagnostic category.
DTC Descriptor
DTC B0988 4B
- Vehicle Direction Alert Alarm Warning Camera Calibration Not Learned
Circuit/System Description
The lane departure warning system is controlled by the vehicle direction alert alarm warning (VDAAW) module mounted on the windshield. Lane departure warning is enabled and disabled through a switch located in the headlamp switch assembly. When enabled, the VDAAW module will illuminate the indicator located in the switch.
When the system is operating and can detect the lane markings, the VDAAW module will request via serial data communications that the instrument panel cluster (IPC) illuminate the green lane departure ready-to-assist indicator. If the VDAAW module detects that the vehicle has crosses a lane marking without the turn signal being used, the module will request that the IPC flash the yellow lane departure warning indicator. An audible warning will also sound three times when the yellow IPC indicator is flashing.
Conditions for Running the DTC
Ignition ON
Conditions for Setting the DTC
The VDAAW module does not have a valid calibration file.
Action Taken When the DTC Sets
* Lane departure warning is disabled
* SERVICE LANE DEPARTURE SYSTEM is displayed on the DIC.
Conditions for Clearing the DTC
* A valid calibration file is present in the VDAAW module.
* A history DTC will clear once 100 consecutive malfunction-free ignition cycles have occurred.
Reference Information
Schematic Reference
Object Detection Schematics ([1][2]Collision Avoidance and Parking Assist Systems)
Connector End View Reference
Component Connector End Views (Connector End Views By Name)
Description and Operation
Object Detection Description and Operation Description and Operation
Electrical Information Reference
* Circuit Testing (Circuit Testing)
* Connector Repairs (Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (Wiring Repairs)
Scan Tool Reference
Control Module References (Programming and Relearning)for scan tool information
Circuit/System Verification
Verify DTC B0988 is not set.
If the DTC is set, replace the vehicle direction alert alarm warning module.
Repair Instructions
Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.
Control Module References (Programming and Relearning)for vehicle direction alert alarm warning module replacement, setup and programming