Operation CHARM: Car repair manuals for everyone.

P0573




DTC P0572 or P0573

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Strategy Based Diagnosis) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Diagnostic Procedure Instructions)provides an overview of each diagnostic category.

DTC Descriptors
DTC P0572
- Brake Switch Circuit 1 Low Voltage

DTC P0573
- Brake Switch Circuit 1 High Voltage

Diagnostic Fault Information





Circuit/System Description

The body control module (BCM) monitors the brake pedal position sensor. When the brake pedal is applied, the BCM detects a predetermined voltage signal. The BCM sends a serial data message to the engine control module (ECM) indicating the status of the stop lamps.

Conditions for Running the DTC

* The engine is running.
* Battery voltage is greater than 11.5 volts.

Conditions for Setting the DTC

P0572

The ECM/PCM detects a low voltage signal on the stop lamp switch signal circuit when the serial data message from the BCM indicates the brakes are applied.

P0573

The ECM/PCM detects a high voltage signal on the stop lamp switch signal circuit when the serial data message from the BCM indicates the brakes are not applied.

Actions Taken When the DTC Sets

* The malfunction indicator lamp (MIL) will not illuminate.
* The cruise control system is disabled.

Conditions for Clearing the DTC

* The condition responsible for setting the DTC no longer exists.
* A history DTC will clear after 40 malfunction-free ignition cycles.

Reference Information
Schematic Reference

* Exterior Lights Schematics (Exterior Lights Schematics)
* Cruise Control Schematics (Electrical Diagrams)

Connector End View Reference

Component Connector End Views (Connector End Views By Name)
Description and Operation

Cruise Control Description and Operation Description and Operation
Electrical Information Reference

* Circuit Testing (Circuit Testing)
* Connector Repairs (Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (Wiring Repairs)

Scan Tool Reference

Control Module References (Programming and Relearning)for scan tool information

Circuit/System Testing

1. Ignition OFF, disconnect the harness connectors at the appropriate control modules listed below.

* ECM X1
* TCM

2. Connect a test lamp between the appropriate signal circuit terminal listed below and ground.

* ECM terminal 7
* TCM terminal 42

3. Ignition ON, verify the test lamp turns ON and OFF while pressing and releasing the brake pedal.

If the test lamp is always ON, test the signal circuit for a short to voltage. If the circuit tests normal, replace the BCM.
If the test lamp is always OFF, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the BCM.

4. Ignition OFF, connect the harness connector at the TCM.
5. Connect a test lamp between the signal circuit terminal 7 and ground.
6. Ignition ON, verify the test lamp turns ON and OFF while pressing and releasing the brake pedal.

If the test lamp is always OFF, test the signal circuit for an open/high resistance. If the circuit test normal, replace the TCM.

7. If all circuits test normal, replace the ECM.

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

Control Module References (Programming and Relearning)for ECM or TCM module replacement, setup, and programming