82. Camshaft Cover Assemble

Camshaft Cover Assemble

Special Tools
* DT 5590 - Bearing and Seal Driver
* EN 24254-A - Oil Seal Installer

For equivalent regional tools, refer to Special Tools (Special Tools).

Left Camshaft Cover




1. Install the NEW left spark plug shield tube seals using the DT 5590 - driver (1) and EN 24254-A - installer (2).




2. Install the NEW left camshaft cover gasket.




3. Install the oil fill tube (3) and oil fill tube O-ring (4) if a NEW camshaft cover and oil fill tube are being assembled. Lightly lubricate the O-ring with engine oil before inserting the oil fill tube into the camshaft cover. Make sure the tube is fully seated into both retaining tangs.
4. Install the oil fill cap (1) and NEW O-ring (2).





Caution: Refer to Fastener Caution (Fastener Caution).

5. Install the fuel injector sight shield cover ball stud and tighten to 10 Nm (89 lb in).





Note: The camshaft cover bolt grommet must be installed into the camshaft cover bolt hole before installing the camshaft cover bolt.

6. Install the NEW left camshaft cover bolt grommets.

Right Camshaft Cover




1. Install the NEW right spark plug shield tube coil seals using the DT 5590 - driver (1) and EN 24254-A - installer (2).




2. Install the NEW right camshaft cover gasket.





Note: The camshaft cover bolt grommet must be installed into the camshaft cover bolt hole before installing the camshaft cover bolt.

3. Install the NEW right camshaft cover bolt grommets.