Air Conditioning Condenser Replacement (Standard Cooling)

Air Conditioning Condenser Replacement (Standard Cooling)

Special Tools

J 39400-A Halogen Leak Detector

Removal Procedure




1. Recover the refrigerant. Refer to Refrigerant Recovery and Recharging (Refrigerant Recovery and Recharging).
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
3. Remove the front air deflector retainers.
4. Remove the front air deflector.
5. Remove the lower air baffle push pin retainers.




6. Remove the condenser upper bracket bolts.




7. Remove the condenser lower mounting bolts.




8. Remove the discharge line bolt.
9. Disconnect the discharge line from the condenser.
10. Remove and discard the O-ring.




11. Remove the condenser tube bolt.
12. Disconnect the condenser tube from the condenser.
13. Remove and discard the O-ring.




14. Remove the power steering cooler line to condenser retaining bolts.
15. Remove the condenser.

Installation Procedure




1. If replacing the condenser, add the specified amount of PAG oil directly to the condenser. Refer to Refrigerant System Specifications (Specifications).
2. Install the condenser.

Caution: Refer to Fastener Caution (Fastener Caution).

3. Install the power steering cooler line to condenser retaining bolts and tighten to 9 Nm (80 lb in).
4. Install a new O-ring to the condenser tube. Refer to Air Conditioning O-Ring Seal Replacement (Service and Repair).
5. Connect the condenser tube to the condenser.




6. Install the condenser tube bolt and tighten to 9 Nm (80 lb in).
7. Install a new O-ring to the discharge line. Refer to Air Conditioning O-Ring Seal Replacement (Service and Repair).
8. Connect the discharge line to the condenser.




9. Install the discharge line bolt and tighten to 9 Nm (80 lb in).




10. Install the condenser lower mounting bolts and tighten to 5.4 Nm (48 lb in).




11. Remove the condenser upper bracket bolts and tighten to 5.4 Nm (48 lb in).
12. Install the lower air baffle push pin retainers.
13. Install the front air deflector.
14. Install the front air deflector retainers.
15. Lower the vehicle.
16. Install the power steering cooler mounting bolts. Refer to Power Steering Fluid Cooler Replacement (LLT or LY7 without V92) (Service and Repair).




17. Evacuate and recharge the A/C system. Refer to Refrigerant Recovery and Recharging (Refrigerant Recovery and Recharging).
18. Leak test the fittings of the component using the J 39400-A .