Park Brake Cable Mounting Bracket Replacement (With Electronic Parking Brake)

Park Brake Cable Mounting Bracket Replacement (With Electronic Parking Brake)

Special Tools

J-37043 - Parking Brake Cable Release Tool

Removal Procedure
Warning: Refer to Brake Dust Warning Brake Dust Warning.


1. Block the rear drive wheels.
2. Release the electronic park brake cable tension, if equipped. Refer to Parking Brake Cable Adjuster Disabling (Electric Park Brake) Parking Brake Cable Adjuster Disabling (Electric Park Brake).
3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.
4. Remove the rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation Service and Repair.
5. Lower, but do not disconnect, the exhaust system enough to gain access to the parking brake cable. Refer to Exhaust System Insulator, Hanger, Bracket Replacement Exhaust System Insulator, Hanger, Bracket Replacement.




6. Pull down on the left parking brake rear cable (1) or the right parking brake rear cable (2) and disconnect the cable from the connector.




7. Using the J-37043 - Parking Brake Cable Release Tool , compress the rear brake cable retainer.
8. Remove the rear park brake cable from the cable bracket (1).
9. Disconnect the park brake cable (2) from the park brake actuator lever (3).




10. Remove the park brake cable bracket nuts (1).
11. Remove the park brake cable bracket.

Installation Procedure




1. Install the park brake cable bracket.

Caution: Refer to Fastener Caution Fastener Caution.

2. Install the park brake cable bracket nuts (1) and tighten to 60 Nm (44 lb ft).




3. Install the park brake cable to the park brake cable bracket (1).
4. Ensure the locking tabs are properly seated.
5. Connect the rear park brake cable (2) to the park brake actuator lever (3).




6. Connect the left parking brake rear cable (1) or the right parking brake rear cable (2) to the connector.
7. Install the exhaust system. Refer to Exhaust System Insulator, Hanger, Bracket Replacement Exhaust System Insulator, Hanger, Bracket Replacement.
8. Install the rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation Service and Repair.
9. Set the electric park brake cable tension. Refer to Parking Brake Cable Adjuster Enabling (Electric Park Brake) Parking Brake Cable Adjuster Enabling (Electric Park Brake).
10. Lower the vehicle.