Park Brake Cable Mounting Bracket Replacement (Without Electronic Parking Brake)

Park Brake Cable Mounting Bracket Replacement (Without Electronic Parking Brake)

Special Tools

J-37043 - Parking Brake Cable Release Tool

Removal Procedure
Warning: Refer to Brake Dust Warning Brake Dust Warning.


1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.
2. Remove the rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation Service and Repair.




3. Pull down on the intermediate park brake cable and disconnect the intermediate park brake cable connector (1) from the front park brake cable (2).




4. Using the J-37043 - Parking Brake Cable Release Tool , compress the rear brake cable retainer.
5. Remove the rear park brake cable from the cable bracket (1).
6. Disconnect the park brake cable (2) from the park brake actuator lever (3).




7. Remove the park brake cable bracket nuts (1).
8. Remove the park brake cable bracket.

Installation Procedure




1. Install the park brake cable bracket.

Caution: Refer to Fastener Caution Fastener Caution.

2. Install the park brake cable bracket nuts (1) and tighten to 60 Nm (44 lb ft).




3. Install the park brake cable to the park brake cable bracket (1).
4. Ensure the locking tabs are properly seated.
5. Connect the rear park brake cable (2) to the park brake actuator lever (3).




6. Connect the intermediate park brake cable connector (1) to the front park brake cable (2).
7. Install the rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation Service and Repair.
8. Lower the vehicle.
9. Cycle the park brake pedal 1 to 2 times.