Liftgate Control Module

Liftgate Control Module - DTC B1019

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor
DTC B1019 00
- System Configuration Error

Circuit/System Description

When calibrating the liftgate position, the liftgate control module is placed in a functional state to learn the liftgate travel limits. DTC B1019 00 will set automatically as an indicator that the system is in learn mode and not as a fault indicator. Once the travel limits are learned by the liftgate control module, the liftgate control module will exit calibration mode and DTC B1019 00 become a history code.

Conditions for Running the DTC

The system voltage is 9-18 V.

Conditions for Setting the DTC

Whenever the liftgate control module is replaced or in learn mode.

Action Taken When the DTC Sets

The power liftgate system will be disabled.

Conditions for Clearing the DTC

* The DTC will be current until the liftgate calibration procedure has been completed.
* When the calibration procedure has been completed the DTC will be a history DTC.

Diagnostic Aids

Setting B1019 00 is normal after flashing the liftgate control module. This DTC will be current after flashing and the DTC will go to history after learning. This is a normal behavior by design and is not necessary to replace the liftgate control module.

Reference Information
Schematic Reference

Liftgate Schematics Liftgate Schematics
Connector End View Reference

Component Connector End Views Connector Views
Description and Operation

Liftgate Description and Operation Liftgate
Electrical Information Reference

* Circuit Testing Circuit Testing
* Connector Repairs Connector Repairs
* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections
* Wiring Repairs Wiring Repairs

Scan Tool Reference

Control Module References Control Module References for scan tool information

Circuit/System Testing

Perform the Liftgate Calibration Programming and Relearning. The K39 liftgate control module should learn the travel limits, exit the calibration mode, and B1019 00 will become a history code.

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.

Control Module References Control Module References for liftgate control module replacement, setup and programming