Headlamp Leveling Front Suspension Height Sensor Replacement

Headlamp Leveling Front Suspension Height Sensor Replacement

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.
2. Remove the front tire and wheel assembly. Refer to Tire and Wheel Removal and Installation Service and Repair.




3. Disconnect the electrical connector (1).




4. Disconnect the ball and socket (1) from upper control arm.
5. Loosen the clinch nut (2) from the stud.
6. Rotate and remove the sensor from the wheelhouse panel.

Installation Procedure




1. Position and rotate the sensor (1) and the locking tab into the holes in the wheelhouse panel.





Caution: Refer to Fastener Caution Fastener Caution.

2. Secure the clinch nut (2) on the stud to the wheelhouse panel and tighten to 9 Nm (80 lb in).
3. Lock the ball socket (1) to upper control arm ball stud.




4. Connect the electrical connector (1) to the sensor assembly.
5. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation Service and Repair.
6. Lower the vehicle.
7. Set up and program the headlamp control module. Refer to Control Module References Control Module References.