Headlamp Leveling Rear Suspension Height Sensor Replacement

Headlamp Leveling Rear Suspension Height Sensor Replacement

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.
2. Remove the right rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation Service and Repair.




3. Disconnect electrical connector (2).
4. Disconnect the ball and socket (3) from vehicle.
5. Loosen the clinch nut (1) from the sensor.
6. Remove the sensor from the vehicle.

Installation Procedure




1. Position the sensor (3) to the vehicle and engage the locking tab to the wheelhouse bracket.
2. Secure the clinch nut (1) in order to secure the sensor (4) to the vehicle.

Tighten 9 Nm (80 lb in).

3. Secure the ball and socket (3) to sensor (4).
4. Connect electrical connector (2) to the sensor (4).
5. Install the right tire and wheel assembly. Refer to Tire and Wheel Removal and Installation Service and Repair.
6. Lower the vehicle.
7. Set up and program the headlamp control module. Refer to Control Module References Control Module References.