134. Engine Flywheel Installation (Manual Transmission)

Engine Flywheel Installation (Manual Transmission)

Special Tools
* EN 46106 - Flywheel Holding Tool
* J 33169 - Clutch Alignment Arbor

For equivalent regional tools, refer to Special Tools Special Tools.

1. Place the engine flywheel in position on the crankshaft.
2. Install 2 NEW bolts in location at the top and bottom of the engine flywheel bolt pattern allowing the engine flywheel to hang in position.




3. Install the EN 46106 - tool.





Caution: Refer to Fastener Caution Fastener Caution.

4. Install the remaining NEW engine flywheel bolts and tighten the NEW engine flywheel bolts to 67 Nm (49 lb ft).




5. Install the clutch driven plate disc and the clutch pressure plate to the engine flywheel. Ensure to align the clutch pressure plate to the pins in the engine flywheel.
6. Loosely install the clutch pressure plate bolts.




7. Install the J 33169 - arbor through the clutch driven plate disc and into the end of the crankshaft in order to align the clutch driven plate disc.
8. Tighten the clutch pressure plate bolts to 30 Nm (22 lb ft).
9. Remove the J 33169 - arbor.




10. Remove the EN 46106 - tool.