Suspension Control Module: Service and Repair

Electronic Suspension Control Module Replacement

Removal Procedure

1. Remove the left rear trim panel.




2. Loosen the electronic suspension control (ESC) module nuts.
3. Disconnect the ESC module electrical connector (1).
4. Remove the ESC module (2).

Installation Procedure




1. Install the ESC module (2).
2. Connect the ESC module electrical connector (1).

Caution: Refer to Fastener Caution Fastener Caution.

3. Tighten the ESC module nuts to 9 Nm (80 lb in).
4. Install the left rear trim panel.
5. Refer to Control Module References Control Module References for programming and setup information.