C0292
DTC C0292
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.
DTC Descriptors
DTC C0292 02
-
VSES Combination Sensor Circuit Short to Ground
DTC C0292 07
-
VSES Combination Sensor Circuit Voltage Above Threshold
Circuit/System Description
The electronic brake control module (EBCM) supplies a ignition voltage to the yaw rate sensor/lateral acceleration sensor, and the steering angle sensor. The sensor supply voltage is monitored via an internal feedback circuit to the EBCM microprocessor.
Conditions for Running the DTC
* Ignition ON.
* Ignition voltage is greater than 10 volts.
Conditions for Setting the DTC
The EBCM detects a short to ground or an open/high resistance on the sensor supply voltage
Actions Taken when the DTC Sets
* The EBCM disables StabiliTrak for the duration of the ignition cycle.
* A DIC message and/or a warning indicator may be displayed.
Conditions for Clearing the DTC
* The condition for the DTC is no longer present.
* The EBCM clears the history DTC when a current DTC is not detected in 40 consecutive drive cycles.
Reference Information
Schematic Reference
Antilock Brake System Schematics [1][2]Antilock Brakes / Traction Control Systems
Connector End View Reference
Component Connector End Views A/C Compressor Clutch
Description and Operation
ABS Description and Operation Description and Operation
Electrical Information Reference
* Circuit Testing Circuit Testing
* Connector Repairs Connector Repairs
* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections
* Wiring Repairs Wiring Repairs
Scan Tool Reference
Control Module References Control Module References for scan tool information
Circuit/System Testing
1. Ignition ON, verify that DTCs U1826, or U1827 are not set.
• If any of the DTCs are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle Diagnostic Trouble Code (DTC) List - Vehicle
2. Ignition OFF, disconnect the yaw/lateral acceleration sensor connector.
3. Ignition OFF wait 1 minute, test for less than 10 ohms between the low reference circuit terminal 6 and ground.
• If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuits test normal, replace the EBCM.
4. Ignition ON, test for B+ between the ignition circuit terminal 1 and ground.
• If less than the specified value, test the ignition circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the EBCM.
5. If all circuits test normal, replace the yaw/lateral accelerometer sensor.
Repair Instructions
Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.
* Vehicle Yaw Sensor with Vehicle Lateral Accelerometer Replacement Service and Repair
* Control Module References Control Module References for EBCM replacement, setup, and programming