Clutch Pilot Bearing Installation

Clutch Pilot Bearing Installation (Non-LS9)

Special Tools

* J 8433 - Two Jaw Puller

* J 45949 - Pilot Bearing and Flywheel Locator Installer





1. Position the bearing to the rear of the crankshaft.

2. Assemble the J 8433 - two jaw puller (2), the J 45949 - pilot bearing and flywheel locator installer (1) and bolts to the rear of the crankshaft.

Tighten the bolts until snug.

3. Rotate the bolt of the J 8433 - two jaw puller (2) until the bearing is seated in the bore of the crankshaft.

4. Remove the tools.





5. Inspect the clutch pilot bearing for proper installation.