Power Steering
DTC C0569
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions Diagnostic Procedure Instructions provides an overview of each diagnostic category.
DTC Descriptor
DTC C0569 31
- Internal Check Sum Error
DTC C0569 42
- Calibration Not Programmed
DTC C0569 46
- Configuration Not Programmed
Circuit/System Description
The power steering control module continuously monitors the parameters of the steering gear. The power steering
control module performs a self-test diagnostic during power-up. The configuration is not complete from supplier.
Conditions for Running the DTC
Ignition ON.
Conditions for Setting the DTC
Electronic power steering control module configuration is not complete.
Action Taken When the DTC Sets
* DTC C0569 is stored in memory.
* No Steering assist.
Conditions for Clearing the DTC
A history DTC will clear after 40 consecutive malfunction free ignition cycles.
Reference Information
Schematic Reference
Power Steering Schematics Electrical Diagrams
Connector End View Reference
Component Connector End Views Fuel Pump and Level Sensor Assembly
Description and Operation
Power Steering System Description and Operation (NJ2) Power Steering System Description and Operation (NJ2)Power Steering System Description and Operation (NXC) Power Steering System Description and Operation (NXC)
Electrical Information Reference
* Circuit Testing Circuit Testing
* Connector Repairs Connector Repairs
* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections
* Wiring Repairs Wiring Repairs
Scan Tool Reference
Control Module References Control Module References for scan tool information.
Circuit/System Verification
1. Ignition ON.
2. Verify that DTC C0569 is not set.
• If the DTC C0569 is set
Replace the steering gear
• If the DTC C0569 is not set
3. All OK.
Repair Instructions
Perform the Diagnostic Repair Verification Verification Tests after completing the repair.
* Steering Gear Replacement (FWD) Steering Gear ReplacementSteering Gear Replacement (AWD) Steering Gear Replacement
* Control Module References Control Module References for power steering control module replacement, programming and setup.