Operation CHARM: Car repair manuals for everyone.

Control Module: Testing and Inspection





Control Solenoid Valve and Transmission Control Module Assembly Programming and Setup

Note:
* DO NOT program a control module unless directed to by a service procedure or a service bulletin. If the control module is not properly configured with the correct calibration software, the control module will not control all of the vehicle features properly.
* Ensure the programming tool is equipped with the latest software and is securely connected to the data link connector. If there is an interruption during programming, programming failure or control module damage may occur.
* Stable battery voltage is critical during programming. Any fluctuation, spiking, over voltage or loss of voltage will interrupt programming. When required, install the EL-49642 SPS Programming Support Tool to maintain system voltage. If not available, connect a fully charged 12 V jumper or booster pack disconnected from the AC voltage supply. DO NOT connect a battery charger.
* Turn OFF or disable systems that may put a load on the vehicles battery such as; interior lights, exterior lights (including daytime running lights), HVAC, radio, etc.
* During the programming procedure, follow the SPS prompts for the correct ignition switch position.
* Clear DTCs after programming is complete. Clearing powertrain DTCs will set the Inspection/Maintenance (I/M) system status indicators to NO.

Reference Information

Special Tools
EL-49642 SPS Programming Support Tool
For equivalent regional tools, refer to Special Tools Tools and Equipment.

Replace and Program Control Module
To program a replacement transmission control module (TCM), perform the following procedure:
1. Install EL-49642 SPS Programming Support Tool.
2. Access the Service Programming System (SPS) and follow the on-screen instructions.
3. On the SPS Supported Controllers screen, select Transmission Control Module - Programming and follow the on-screen instructions.
4. At the end of programming, choose the Clear All DTCs function on the SPS screen.
5. With a scan tool, perform the Reset Transmission Adapts. Refer to Reset Transmission Adapts Reset Procedure.

Reprogram Control Module
To reprogram an existing TCM, perform the following procedure:
1. Access the Service Programming System (SPS) and follow the on-screen instructions.
2. On the SPS Supported Controllers screen, select Transmission Control Module - Programming and follow the on-screen instructions.
3. At the end of programming, choose the learn All DTCs function on the SPS screen.
4. With a scan tool, perform the Reset Transmission Adapts. Refer to Reset Transmission Adapts Reset Procedure.

Unsuccessful Programming Recovery
In the event of an interrupted or unsuccessful programming event, perform the following:
1. Ignition ON. Ensure the control module, DLC and programming tool connections are secure and the SPS software is up to date.
2. Verify the control module can be reprogrammed.
If the control module cannot be reprogrammed
2.1 Ignition OFF for one minute, ignition ON.
2.2 Verify the control module can be reprogrammed.
If the control module cannot be reprogrammed, replace the control module.
If the control module can be reprogrammed.
2.3 All OK.
If the control module can be reprogrammed
3. All OK.

Repair Instructions
Perform the Diagnostic Repair Verification Verification Tests after completing the repair.

Refer to Control Module References Control Module References for control module replacement, programming, and setup.