Front Wheel Speed Sensor Replacement (J64)

Front Wheel Speed Sensor Replacement (J64)

Removal Procedure

Warning: Refer to Brake Dust Warning Brake Dust Warning.


1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.

2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation Service and Repair.




3. Unlock and disconnect the wheel speed sensor electrical connector (1). Refer to Electronic Suspension Position Sensor Front Jumper Harness Disconnection Removal and Replacement.




4. Release the wheel speed sensor harness grommet (1) from the strut bracket.

5. Clean the wheel speed sensor mounting area on the steering knuckle of any accumulated dirt and debris.




6. Remove the wheel speed sensor bolt (1).




7. Remove the wheel speed sensor (1) from the steering knuckle.

Installation Procedure




1. Install the wheel speed sensor (1) to the steering knuckle.





Caution: Refer to Fastener Caution Fastener Caution.

2. Install the wheel speed sensor bolt (1) and tighten to 9 Nm (80 lb in).




3. Install the wheel speed sensor harness grommet (1) to the strut bracket.




4. Lock and connect the wheel speed sensor electrical connector (1). Refer to Electronic Suspension Position Sensor Front Jumper Harness Disconnection Removal and Replacement.

5. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation Service and Repair.

6. Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle.