Rear Toe Adjustment

Rear Toe Adjustment




1. Measure the alignment on an alignment rack. Refer to Wheel Alignment Measurement Wheel Alignment Measurement.

Note: Do not tighten the new fasteners yet in order to allow for movement.

2. If adjustment is necessary, remove rear cam bolt and nut. Replace with NEW only.

3. Rotate the cam nut in order to adjust the toe angle. Refer to Wheel Alignment Specifications Wheel Alignment Specifications.

4. Hand tighten the cam bolt, but do not tighten the bolt to the specification yet.

5. Re-inspect the rear toe angle and adjust as necessary.

Caution: This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.

Caution: Refer to Fastener Caution Fastener Caution.

6. Hold the NEW cam bolt and tighten the NEW cam nut.

150 Nm (111 lb ft)

7. Repeat the procedure for the other rear wheel.

8. Lower the vehicle.