Front View Camera Module Programming and Setup

Front View Camera Module Programming and Setup

Note:

* DO NOT program a control module unless directed to by a service procedure or a service bulletin. If the Front View Camera Module is not properly configured with the correct calibration software, the Front View Camera Module will not control all of the vehicle features properly.

* Ensure the programming tool is equipped with the latest software and is securely connected to the data link connector. If there is an interruption during programming, programming failure or Front View Camera Module damage may occur.

* Stable battery voltage is critical during programming. Any fluctuation, spiking, over voltage or loss of voltage will interrupt programming. Install the EL-49642 - SPS Programming Support Tool to maintain system voltage. If not available, connect a fully charged 12 V jumper or booster pack disconnected from the AC voltage supply. DO NOT connect a battery charger.

* Turn OFF or disable systems that may put a load on the vehicles battery such as; interior lights, exterior lights (including daytime running lights), HVAC, radio, etc.

* During the programming procedure, follow the SPS prompts for the correct ignition switch position.

* Clear DTCs after programming is complete. Clearing powertrain DTCs will set the Inspection/Maintenance (I/M) system status indicators to NO.

Replace and Program Front View Camera Module or Reprogram Front View Camera Module (without UGN)

To program a replacement or an existing Front View Camera Module, perform the following procedure:

1. Install EL-49642 - SPS Programming Support Tool.

2. Access the Service Programming System (SPS) and follow the on-screen instructions.

3. On the SPS Supported Controllers screen, select K109 Frontview Camera Module - Programming and follow the on-screen instructions.

4. On the SPS Supported Controllers screen, select K109 Frontview Camera Module - Setup and follow the on-screen instructions.

5. On the SPS Supported Controllers screen, select K109 Frontview Camera Module - Configuration and follow the on-screen instructions.

6. On the SPS Supported Controllers screen, select K109 Frontview Camera Module - Learn / Setup and follow the on-screen instructions.

7. At the end of programming, choose the "Clear All DTCs" function on the SPS screen.

8. Following K109 Frontview Camera Module replacement and reprogramming, the module must be calibrated. Refer to Front View Camera Module Calibration Front View Camera Module Calibration

Replace and Program Front View Camera Module or Reprogram Front View Camera Module (with UGN)

To program a replacement or an existing Front View Camera Module, perform the following procedure:

1. Install EL-49642 - SPS Programming Support Tool.

2. Access the Service Programming System (SPS) and follow the on-screen instructions.

3. On the SPS Supported Controllers screen, select K109 Frontview Camera Module - Programming and follow the on-screen instructions.

4. On the SPS Supported Controllers screen, select K109 Frontview Camera Module - Setup and follow the on-screen instructions.

5. On the SPS Supported Controllers screen, select K109 Frontview Camera Module - Configuration and follow the on-screen instructions.

6. If reprogramming an existing module that was previously calibrated, recalibration is not required. The module retains it's calibration settings during reprogramming.

7. If a new module was programmed the module alignment must be calibrated. Using GDSII, initiate the learn procedure for Frontview Camera Module.
Refer to Front View Camera Module Calibration Front View Camera Module Calibration.

Unsuccessful Programming Recovery

In the event of an interrupted or unsuccessful programming event, perform the following steps:

1. DO NOT turn the ignition OFF. Ensure that all Front View Camera Module, DLC and programming tool connections are secure and the TIS terminal operating software is up to date.

2. Attempt to reprogram the Front View Camera Module.

3. If the Front View Camera Module can still not be programmed, turn the ignition OFF for at least one minute.

4. Turn the ignition ON and attempt to reprogram the Front View Camera Module. The Front View Camera Module should program.

• If the Front View Camera Module still cannot be programmed, replace the Front View Camera Module.