Front Wheel Bearing and Hub Replacement (GNA)

Front Wheel Bearing and Hub Replacement (GNA)

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.

2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation Service and Repair.

3. Remove the front brake rotor. Refer to Front Brake Rotor Replacement (J64) Front Brake Rotor Replacement (J64)Front Brake Rotor Replacement (J55) Front Brake Rotor Replacement (J55).

4. Disconnect the front wheel drive shaft from the front wheel bearing and hub assembly. Refer to Front Wheel Drive Shaft Replacement - Left Side Front Wheel Drive Shaft Replacement - Left Side or Front Wheel Drive Shaft Replacement - Right Side Front Wheel Drive Shaft Replacement - Right Side.




5. Remove the front wheel bearing and hub assembly bolts (1). Discard the bolts.




6. Remove the front wheel bearing and hub assembly (1) and front brake shield (2) from the steering knuckle.

Installation Procedure




1. Position the front brake shield (2) and wheel bearing and hub assembly (1) on the steering knuckle.




2. Install the front wheel bearing and hub assembly bolts (1). Use NEW bolts.

Caution: Refer to Fastener Caution Fastener Caution.

3. Tighten the front wheel bearing and hub assembly bolts (1) to 100 Nm (74 lb ft) + 75 degrees.

4. Connect the front wheel drive shaft to the front wheel bearing and hub assembly. Refer to Front Wheel Drive Shaft Replacement - Left Side Front Wheel Drive Shaft Replacement - Left Side or Front Wheel Drive Shaft Replacement - Right Side Front Wheel Drive Shaft Replacement - Right Side.

5. Install the front brake rotor. Refer to Front Brake Rotor Replacement (J64) Front Brake Rotor Replacement (J64)Front Brake Rotor Replacement (J55) Front Brake Rotor Replacement (J55).

6. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation Service and Repair.