Service Procedure

1. Open hood and locate the Emission Label on the passenger side strut tower Refer to # 1 in Figure 1.

2. Use a clean, dry cloth to wipe dirt, oil, etc. from the label currently on the vehicle.

3. Remove backing from new label.

Notice:
Do not attempt to remove or loosen the new label once it has been installed because this will deface the label.

4. Apply new label over the existing label. Smooth the label by starting at the center of the label using a clean, dry cloth.

5. Air bubbles can be removed by puncturing the bubble with a pin and smoothing them with a cloth.

b. Install Campaign Identification Label.