Ignition Coil: Service and Repair

Ignition Coil:

Ignition Coil And Ignition Control Module:

Numbers used below refer to image caption.

REMOVE OR DISCONNECT
1. Be sure ignition switch is in "OFF" or "LOCK" position.
2. Four-terminal Powertrain Control Module (PCM) connector at ignition coil module.
3. Ignition coil wiring connectors.
4. Ignition coil harness.
5. Studs (5).
6. Ignition coil / Ignition Control Module assembly (8).

^ Do not wipe silicone grease from bottom of ignition coil assembly (8) if it is to he reinstalled.

NOTICE: If a new ignition coil assembly is to be installed, a package of silicone grease will be included in the box. This grease is necessary for ignition coil assembly cooling.



INSTALL OR CONNECT
1. Spread silicone grease on metal mounting face of ignition coil bracket (14) if necessary, and position ignition coil / Ignition Control module assembly (8) to cylinder head assembly.
2. Studs (5).

Tighten
^ Studs (5) to 25 Nm (18 lb ft.).

3. Ignition coil harness.
4. Ignition coil wiring connectors.
5. Four terminal PCM connector to ignition coil module.