Front Door - Window Regulator Replacement

Front Side Door Window Regulator:

Locking Sector Gear:

Caution: Approved safety glasses and a gloves should be worn when performing these procedures to reduce the chance of personal injury should window breakage occur.

Caution: Make sure to disconnect the power window switch when working Inside the driver's door. When operated, the Express Down feature allows the door window to drop very quickly which could cause personal injury.

Remove or Disconnect
1. Place window in the halfway position.

2. Front side door trim. Refer to Door Panel / Service and Repair. Doors

3. Water deflector as needed.

Caution: Support front side door window. if window drops into door, personal injury or window damage may result.

4. Support window in position by inserting rubber wedge door stops at front and rear of window between window and door inner panel.

5. Window rear guide channel nuts so rear guide channel can be moved.

6. Window regulator rivets (23).

A. Push rivet mandrel out of regulator rivet (23) with a punch.
B. Drill out regulator rivet (23).
C. Remove rivet fragments from hole.

7. Electrical connector from regulator motor (83) by sliding motor (83) and regulator (82) rearward, if equipped.

8. Window regulator (20 or 82) from channels.

9. Window regulator (20 or 82), with regulator motor (83) attached if equipped, through rear access hole.

Install or Connect
1. Window regulator (20 or 82), with regulator motor (83) attached if equipped, through rear access hole.

2. Window Regulator (20 or 82) to channels.

3. Electrical connector to regulator motor (83), if equipped.

4. Regulator rivets (23) in sequence as shown in image.

5. Window rear guide channel nuts.

Inspect: Window aligN.ment. Adjust if necessary.

6. Water deflector.

7. Front side door trim. Refer to Door Panel / Service and Repair. Doors