Cruise Control Release Switch and Stoplamp Switch Replacement

CAUTION:
^ This vehicle has a Supplemental Inflatable Restraint (SIR) System. Refer to the SIR Component and Wiring Location View in order to determine whether you are performing service on or near the SIR components or the SIR wiring. When you are performing service on or near the SIR components or the SIR wiring, refer to the SIR On-Vehicle Service information. Failure to follow the CAUTIONS could cause air bag deployment, personal injury, or unnecessary SIR system repairs.
^ Before removing or installing any electrical unit, or when a tool or equipment could easily come in contact with live or hot at all times exposed electrical terminals, disconnect the battery negative cable to help prevent personal injury and/or damage to the vehicle or components. Unless instructed otherwise, the ignition switch must be in the OFF or LOCK position.

REMOVE OR DISCONNECT
1. LH I/P insulator panel.
2. Electrical connector(s) from switch(es).
3. Switch(es) from retainer(s) in brake pedal bracket.

INSTALL OR CONNECT
1. Switch(es) to retainer(s) in brake pedal bracket.
2. Electrical connector(s) onto switch(es).

Adjust
^ Release switch(es).