Brake Fluid Level Sensor/Switch: Service and Repair

REMOVAL PROCEDURE





1. Disconnect low brake fluid sensor electrical connector (2) from sensor (1).





2. Using needlenose pliers, remove sensor from reservoir by squeezing the outer tangs together and removing sensor by hand.

IMPORTANT: If sensor is being replaced, remove and replace the sensor float that resides within the master cylinder reservoir.

INSTALLATION PROCEDURE





1. Insert the low brake fluid sensor and float sensor if removed into reservoir cavity ensuring it is fully seated. Sensor should "snap" into position as the tangs engage.





2. Connect the low brake fluid sensor electrical connector to the sensor.