Ignition Coil: Service and Repair

REMOVAL PROCEDURE

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.

1. Disconnect the negative battery cable.
2. Disconnect the spark plug wires (note position that the wires are removed).
3. Remove 2 screws (1) securing the coil (2) to the ignition control module (3).
4. Remove the coil (1).

INSTALLATION PROCEDURE
1. Attach the coil assembly to the ignition control module.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install two attaching screws.

Tighten
Tighten the screws to 4 - 5 N.m (40 lb in).

3. Connect the spark plug wires.

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.

4. Reconnect the negative battery cable.