At Console Shift Control

Removal Procedure

Caution: Refer to Automatic Transaxle Range Selector Cable Caution in Service Precautions.





1. Remove the automatic transaxle range selector cable from wiring harness retainers in the engine compartment.
2. Remove the console. Refer to Console Replacement - Front Floor (Impala) or Console Replacement - Front Floor (Monte Carlo) in Instrument Panel, Gauges and Warning Indicators.
3. Pull the carpet back to expose the automatic transaxle range selector cable. Refer to Carpet Replacement - Front in Body and Frame.
4. Remove the automatic transaxle range selector cable from the retainers in the passenger compartment.





5. Disengage the automatic transaxle range selector cable retainer to the console shift control.





6. Remove the automatic transaxle range selector cable retainer from the console shift control.





7. Remove the automatic transaxle range selector cable from the console shift control.





8. Remove the automatic transaxle range selector cable through the hole in the cowl.
9. Remove the automatic transaxle range selector cable from the manual shaft. Refer to Automatic Transmission Range Selector Cable Replacement (New Cable Installation Only) or Automatic Transmission Range Selector Cable Replacement (At Manual Shaft) or Automatic Transmission Range Selector Cable Replacement (At Console Shift Control) or Automatic Transmission Range Selector Cable Replacement (At Column Shift Control).

Installation Procedure

Caution: Refer to Automatic Transaxle Range Selector Cable Caution in Service Precautions.





1. Properly route and position the automatic transaxle range selector cable.





2. Install the automatic transaxle range selector cable through the hole in the cowl.
3. Install the automatic transaxle range selector cable to the manual shaft. Refer to Automatic Transmission Range Selector Cable Replacement (New Cable Installation Only) or Automatic Transmission Range Selector Cable Replacement (At Manual Shaft) or Automatic Transmission Range Selector Cable Replacement (At Console Shift Control) or Automatic Transmission Range Selector Cable Replacement (At Column Shift Control).





4. Install the automatic transaxle range selector cable through the console shift control bracket.





5. Install the automatic transaxle range selector cable to the console shift control.





6. Engage the automatic transaxle range selector cable retainer to the console shift control.
7. Install the automatic transaxle range selector cable to the retainers in the passenger compartment.
8. Install the carpet into position. Refer to Carpet Replacement - Front in Body and Frame.
9. Install the console. Refer to Console Replacement - Front Floor (Impala) or Console Replacement Front Floor (Monte Carlo) in Instrument Panel, Gauges and Warning Indicators.





10. Install the automatic transaxle range selector cable to the wiring harness retainers in the engine compartment.
11. Adjust the automatic transaxle range selector cable. Refer to Automatic Transmission Range Selector Cable Adjustment.