Power Steering Return Hose Replacement

Power Steering Return Hose Replacement

Removal Procedure





1. Remove the clamp (4) and the power steering return hose (3) from the steering pump (1).
2. Raise the vehicle on a hoist. Refer to Vehicle Lifting.
3. Remove the front exhaust pipe, automatic transmission only.





4. Remove the power steering return hose (4) from the steering gear (3).
5. Remove the power steering return hose retainer nut (5).
6. Remove the power steering return hose (4) from the vehicle.

Installation Procedure

Notice: Refer to Installing Hoses Without Twists or Bends Notice in Service Precautions.





1. Install the power steering return hose (4) to the vehicle.

Notice: Refer to Fastener Notice in Service Precaution.

2. Install the power steering return hose retainer nut (5).
Tighten the nut to 13 Nm (10 ft. lbs.).
3. Install the power steering return hose (4) to the power steering gear (3).
Tighten the fitting to 27 Nm (20 ft. lbs.).
4. Install the front exhaust pipe, if removed.
5. Lower the vehicle.





6. Install the power steering return hose (3) and the clamp (4) to the power steering pump (1).
7. Bleed the power steering system.