Shift Control Shift Closeout Boot Replacement
Shift Control Shift Closeout Boot ReplacementRemoval Procedure
1. Remove the console.
2. Carefully pry off the shift control knob button.
3. Pry the shift control knob retainer out of the slots and remove the retainer.
4. Unscrew the shift control knob.
5. Grasp the sides of the shift boot and apply light pressure in toward the shift control lever to begin to release the shift boot retaining tabs from the IP accessory trim plate.
6. Using light pressure, continue to release the remaining boot retaining tabs.
7. Lift the boot away from the trim plate and remove the boot.
8. Remove the IP accessory trim plate.
9. Remove the shift closeout boot retaining nuts.
10. Remove the shift control closeout boot.
Installation Procedure
1. Install the shift control closeout boot.
Check that the closeout boot fully seats to the shift control lever seal and the base of the shift control assembly (1).
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the shift control closeout boot retaining nuts.
Tighten the shift control closeout boot retaining nuts to 12 Nm (106 inch lbs.).
3. Install the IP accessory trim plate.
4. Install the shift control boot over the shift control lever.
5. Align the shift boot to the IP accessory trim plate opening, then press to lock the boot retaining tabs.
6. Adjust the shape of the boot for appearance, if necessary.
7. Screw the shift control knob onto the shift control lever until the knob bottoms out.
8. Unscrew the shift control knob just enough to align the retainer slot with the slot on the shift control lever.
9. Install the shift control knob retainer (1) into the slots and seat fully.
10. Install the shift control knob button.
11. Install the console.