Rear Suspension

Wheel Bearing/Hub Replacement - Rear

Removal Procedure

1. Remove the rear wheel speed sensor, if equipped.
2. Remove the brake drum.




3. Unstake the caulking nut (4).
4. Remove the caulking nut.

Important: Pull the wheel bearing and hub assembly straight off the spindle. The 2 inner wheel bearing races may not be secure.

5. Remove the wheel bearing and hub assembly (7) from the spindle (1).

Installation Procedure





Important: Slide the wheel bearing and hub assembly straight onto the spindle. Use care in order to properly position the wheel bearing races on the spindle.

1. Install the wheel bearing and hub assembly (7) to the spindle (1).

Notice: Refer to Fastener Notice.

2. Install the caulking nut (4) to the spindle.

Tighten the nut to 190 N.m (140 lb ft).

3. Stake the caulking nut.
4. Install the brake drum.
5. Install the rear wheel speed sensor, if equipped.