Coolant Temperature Sensor/Switch (For Computer): Service and Repair

Engine Coolant Temperature Sensor Replacement

Removal Procedure




1. Relieve the coolant system pressure.

Caution: Refer to Battery Disconnect Caution.

2. Disconnect the negative battery cable.
3. Drain the coolant below the engine coolant temperature (ECT) sensor level.
4. Disconnect the ECT sensor connector.


Notice: Use care when handling the coolant sensor. Damage to the coolant sensor will affect the operation of the fuel control system.

5. Remove the ECT sensor.

Installation Procedure






Notice: Refer to Fastener Notice.

1. Install the ECT sensor.

Tighten the ECT sensor to 20 N.m (15 lb ft).

2. Connect the ECT sensor connector.
3. Fill the cooling system. Refer to Draining and Filling Cooling System.
4. Connect the negative battery cable.