Turn Signal Multifunction Switch Replacement

Turn Signal Multifunction Switch Replacement

Removal Procedure




1. Disconnect the negative battery cable.
2. Remove the lower steering column cover panel screws (6, 7, 8) and remove the lower steering column cover panel (5).
3. Turn the steering wheel to expose the upper steering column cover panel screws (3, 4). Remove the upper steering column cover panel screws and remove the upper steering column cover panel.




4. Remove the turn signal switch by pushing in on the tabs (2, 3) on either side of the switch housing.
5. Disconnect the electrical connectors (1, 4) from the turn signal switch.

Installation Procedure




1. Connect the electrical connectors (1, 4) to the turn signal switch.
2. Install the turn signal switch into the switch housing.

Notice: Refer to Fastener Notice.




3. Turn the steering wheel. Install the upper steering column cover panel (1) and the screws (3, 4).

Tighten the upper steering column cover panel screws to 3 N.m (27 lb in).

4. Install the lower steering column cover panel (5) and the screws (6, 7, 8).

Tighten the lower steering column cover panel screws to 3 N.m (27 lb in).

5. Connect the negative battery cable.