Tie Rod End: Service and Repair

Rack and Pinion Outer Tie Rod End Replacement

Tools Required

KM-507-C Ball Joint Remover

Removal Procedure




1. Remove the outer tie rod hex nut and disconnect the outer tie rod from the steering knuckle using the KM-507-C.





Important: Before loosening the tie rod lock nut, mark the position of the lock nut for easy alignment after the installation procedure.

2. Loosen the tie rod lock nuts and remove the outer tie rod.

Installation Procedure





Notice: Refer to Fastener Notice.

1. Install the outer tie rod with the lock nuts.

Tighten the lock nuts to 54 N.m (40 lb ft).




2. Install the outer tie rod with the hex nut.

Tighten the hex nut to 45 N.m (33 lb ft).

3. Inspect the vehicle.
4. Measure the wheel alignment.
5. If necessary, adjust the front toe.