Operation CHARM: Car repair manuals for everyone.

B0051



DTC B0051

DTC Descriptor

DTC B0051
- Deployment Commanded

Diagnostic Fault Information

Important: Always perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Initial Inspection and Diagnostic Overview

Circuit/System Description

The inflatable restraint sensing and diagnostic module (SDM) contains sensing devices that converts vehicle velocity changes to electrical signals. The SDM processes the generated electrical signals and compares them to values stored in memory. When the generated signals exceed the stored values, the SDM performs additional signal processing and compares the generated signals to signals stored in memory. When 2 of the generated signals exceed the stored values, the SDM will cause current to flow through the inflator modules, deploying the inflator modules, and causing DTC B0051 to set.

Conditions for Running the DTC

Ignition voltage is between 9-16 volts.

Conditions for Setting the DTC

* The SDM detects a frontal impact of sufficient force to warrant deployment of the frontal modules.
* The SDM detects a side impact of sufficient force to warrant deployment of a side impact module.

Action Taken When the DTC Sets

* The SDM commands the AIR BAG warning lamp ON via serial data communication.
* The SDM records crash data.

Conditions for Clearing the DTC

DTC B0051 is a latched code. You cannot clear a latched code. Replace the SDM after following the instructions.

Circuit/System Testing

1. Ignition OFF, inspect the vehicle for signs of inflator module or pretensioner deployment. Verify that the vehicle does not show any signs of inflator deployment.

If the vehicle displays any signs of inflator deployment go to Repairs and Inspections Required After a Collision.

2. Use a scan tool and observe the SIR DTC display, refer to Diagnostic Trouble Code (DTC) List - Vehicle. The scan tool should indicate DTC B0051 is not set. Diagnostic Trouble Code Descriptions

If DTC B0051 is set then replace the SDM.

Repair Instructions

Important: Always perform the Diagnostic Repair Verification after completing the diagnostic procedure. Verification Tests

Refer to Programming and Relearning.Programming and Relearning