B3205

DTC B3205

DTC Descriptor
DTC B3205
- Left Front/Driver Window Motor Circuit

Diagnostic Fault Information

Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Initial Inspection and Diagnostic Overview

Circuit/System Description

The driver door module (DDM) and passenger door module (PDM) check for hall sensor pulses and relay feedback of their respective window motors at least once every 50 milliseconds. When the DDM or PDM detects no hall sensor pulses or relay feedback in the window motor, a DTC is set. For more detailed information concerning power window operation refer to Power Windows Description and Operation.

Conditions for Running the DTC

Battery voltage must be between 9-16 volts.

Conditions for Setting the DTC

* The DDM or PDM detects no hall sensor pulses from the power window motor.
* The DDM or PDM detects no relay feedback from the power window motor.

Actions Taken When the DTC Sets

Loss of window normalization.

Conditions for Clearing the DTC

* The condition responsible for setting the DTC no longer exists.
* You issue a scan tool CLEAR DTCs command.

Diagnostic Aids

The following conditions may cause an intermittent malfunction:

* There is an intermittent sticking or binding window causing the window to be unable to move.
* A window motor is shorted internally.

Circuit/System Testing

Ignition ON, install a scan tool, clear all DTCs and operate the windows within the Conditions for Running the DTC.

If DTC B3205 resets as current, replace the appropriate door control module.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure. Verification Tests

Refer to Programming and Relearning. Programming and Relearning