B3634
DTC B3634
DTC Descriptors
DTC B3634
- Head-Up Display (HUD) Dimming Up Switch Short to Ground.
Diagnostic Fault Information
Important: Always perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Initial Inspection and Diagnostic Overview
Circuit/System Description
The head-up display (HUD) dimming up switch is a momentary press switch that adjusts the HUD display brightness. The HUD dimmer up switch controls the intensity of the brightness. The HUD senses when the dimming up switch is active and adjusts the display brightness until the desired intensity is attained. When the HUD dimming up switch is pressed and the ignition is in the RUN position, the dimming up switch signal to the HUD is low. A press and hold of the dimming up switch greater than 500 msec initiates a smooth increase in the HUD intensity until the switch is released or maximum intensity is achieved.
Conditions for Running the DTC
The ignition is in RUN.
Conditions for Setting the DTC
The HUD detects that the HUD dimming up switch signal circuit is low for greater than 60 seconds.
Action Taken When the DTC Sets
The HUD ignores the malfunctioning switch circuit.
Conditions for Clearing the DTC
* The DTC becomes history when the conditions for setting the DTC are no longer present.
* The HUD receives a clear code command from the scan tool.
Circuit/System Testing
1. Ignition OFF, disconnect the harness connector at the head-up display (HUD).
2. Verify a test lamp does not illuminate when connected between the HUD dimming up switch signal circuit and B+.
• If the test light illuminates, test the HUD dimming up switch signal circuit for a short to ground. If the circuit tests normal, replace the HUD.
3. If all circuits test normal, test or replace the HUD switch.
Repair Instructions
Important: Always perform the Diagnostic Repair Verification after completing the diagnostic procedure. Verification Tests
* Refer to Programming and Relearning.Programming and Relearning
* Head Up Display Switch Replacement